AbiSee Eye-Pal ROL Manuel d'utilisateur télécharger pdf (Page 5)

Power and Battery

Power Switch Button

Power button is located on the front of the device in the lower left corner.

Power Indicator Light

Power indicator light is located above the power button. The light glows steady

green when the device is on; the light blinks when device is in standby mode; the

light is off when the device is turned off.

The power indicator light glows red when the device is off and is being charged.

The power indicator light glows orange when the device is on and is being

charged.

Power Up

Press the POWER button to power the device up. The start-up process takes

approximately 50 seconds. You will hear a series of beeps that let you know that

the device is starting up. When Eye-Pal Ace is ready, you’ll hear the

announcement: “Main Menu: Scan and Read”.

Standby Mode

After five minutes of inactivity, Eye-Pal Ace goes into standby mode, in order to

consume less power. A “power down” beep sound and a blinking power indicator

light indicate that the device is on standby.

Press the power button to wake Eye-Pal Ace up and return it to the active mode.

It will take about 30 seconds for Eye-Pal Ace to “wake up”: you will hear a beep

followed by the announcement: “Main Menu: Scan and Read”.

Power Down

Press and hold the power button for approximately 5 seconds to power down Eye-

Pal Ace completely.

1 2 3 4 5 6 7 8 9 10 ... 20 21

Pas de commentaire

AbiSee Eye-Pal ROL Manuel d'utilisateur Page 5