AbiSee Eye-Pal ROL Manuel d'utilisateur télécharger pdf (Page 9)

Press the Power Button to power up the device. The start-up process takes

approximately 90 seconds. You will hear a series of beeps that let you know the device

is starting up. When the Ace Plus is ready, you will hear the announcement: “Main

Menu: Scan and Read.”

Standby Mode

When operating the device on battery power, after five minutes of inactivity, the Ace

Plus goes into standby mode, in order to consume less power. A short series of tones

indicates when the device is going into this mode, and then a blinking power indicator

light indicates that the device is on standby.

Press the Power Button to wake up the Ace Plus and return it to the active mode.

It will take about 15 seconds for the Ace Plus to “wake up.” You will hear a series of

beeps and when the beeps stop, the device is ready for use. While in sleep mode, the

device will remain in the screen you left off and wake up in the same spot. If you want

to check which screen you are in, press the Center Daisy Button. If you want to return

to the Main Menu, press the Home Button.

Power Down

Press and hold the Power Button for approximately three seconds to power down the

Ace Plus completely. You will hear a short series of beeps as it powers off.

Checking the Battery Charge Status

To quickly check the battery status, press the round Center Daisy Button. You will hear

an announcement that tells the battery status, and whether or not you are connected to

a Network.

The battery status is also announced in the Settings sub-menu under Status. The

Status menu is accessed by pressing the Home Button to get to the Main Menu and

then using the Right Roller to scroll until you hear “Settings.” Next, press the Action

Button to select it. Use the Right Roller again to scroll to Status and press the Action

Button to select it.

The Ace Plus will announce the percentage of available battery charge (also displayed

in the screen): “100%” means a fully charged battery.

If the battery charge is below 15%, it is time to re-charge the device. The Ace Plus can

be used while it is being charged.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 40 41

Pas de commentaire

AbiSee Eye-Pal ROL Manuel d'utilisateur Page 9