AbiSee Eye-Pal SOLO LV Manuel d'utilisateur télécharger pdf (Page 5)

Quick Start for Eye-Pal SOLO LV

Step 1- Turn on the Eye-Pal SOLO LV by holding in the green round button

located on the right side of the front panel.

Step 2- Turn the black volume knob, in the middle of the front panel,

clockwise. A tune will play while the software loads.

Once Eye-Pal SOLO LV is done loading, you will hear “Please place your

document.” You are now ready to read.

Note: Keep the platform clear of any documents until you hear “Please

place your document.”

How to Read with Eye-Pal SOLO LV

To start reading, place a document onto the Eye-Pal SOLO LV base. Place

it in any direction, as the orientation does not matter. You will hear a

“shutter” sound.

Eye-Pal SOLO LV will begin to read your text aloud in a few seconds. With

your monitor or TV connected, you will see the text on the screen.

To magnify the text on the screen, press the Zoom button on the keypad

which is the white square, located on the upper left corner, marked with a

raised black plus sign. Because Eye-Pal SOLO LV “wraps words”, the words

will never run off the screen.

If you remove the document, you will hear, “Please place your document”.

You may either replace the document or resume reading, by pressing the

yellow round Pause/Resume button on the front panel of the base or the

Pause/Resume button on the Keypad.

Note: Eye-Pal SOLO LV can only read text that is within the borders of

the base platform. Any text outside of the borders will not be read. Be

sure not to obstruct the camera’s vision with your hands.

1 2 3 4 5 6 7 8 9 10 ... 15 16

Pas de commentaire

AbiSee Eye-Pal SOLO LV Manuel d'utilisateur Page 5